When The Operation Lamp (Green) Blinks - Daikin FTXZ25NVM Operation Manual

When the OPERATION lamp (green) blinks

OPERATION lamp (green)
When the TIMER lamp (orange)
Dummy
blinks
 Page 36
When the MOLD PROOF /
CLEANING FILTER lamp (green)
blinks
 Page 37
Attention
• When is pressed for about
5 seconds when the
OPERATION lamp is not
blinking, "00" is displayed.
• For other possible failures.
 Page 41 - 45
When the OPERATION lamp (green) blinks, turn off the
circuit breaker. After about 1 minute, turn it on again and
start operation.
If the OPERATION lamp still blinks, check the error code according to the steps below and
take appropriate action.
< To check the error code >
1.
Direct the remote controller toward the
indoor unit and press
5 seconds.
• An error code is displayed on the LCD.
2.
Check the error code and take the action described
below.
Error code
Is the air fi lter soiled or dusty?
A5
• Stop the operation and start the CLEANING FILTER
Turn off the circuit breaker and turn it on again. Then start operation.
Is any foreign object stuck in the outdoor unit fan?
E7
• Turn off the circuit breaker, and then remove foreign objects.
Is the air outlet of the outdoor unit blocked by a car or the
like?
F3,F6,L3,L4,L5
• Turn off the circuit breaker, and then remove the obstruction.
Turn on the circuit breaker and start operation.
Check the model name (or control code *) and contact the service
Other error codes
shop.
3.
Check the OPERATION lamp again and take the action
described below.
OPERATION lamp
Continue the operation for a while and if the OPERATION lamp
Lights up
does not blink, keep on using the air conditioner.
Check the model name (or control code *) and contact the
Blinks again
service shop.
< * To check the control code >
Press again while the error code is
displayed on the LCD.
• A 4-digit control code is displayed on the LCD.
If the model name cannot be checked with the indoor unit, use
this control code for the inquiry.
for about
Check operation and action
operation.  Page 28
Action
40