Daikin FTXS20LVMA Operation Manual page 15

NOTE
„ Note on the angles of the flaps
• The flaps swinging range depends on the operation mode. (See the figure.)
COOL and DRY operation
COMFORT
8°
AIRFLOW
15°
45°
Upper limit
Lower limit
Stop operation
„ Note on 3-D airflow
• Using 3-D airflow circulates cold air, which tends to collected at the bottom of the room, and hot air, which tends to collect near the ceiling,
throughout the room, preventing areas of cold and hot developing.
„ Note on airflow rate setting
• At smaller airflow rates, the cooling (heating) effect is also smaller.
CAUTION
• Always use a remote controller to adjust the angles of the flaps and louvers. If you attempt to move the flaps and louvers forcibly with hand
when they are swinging, the mechanism may be broken.
• Always use a remote controller to adjust the louvers angles. Inside the air outlet, a fan is rotating at a high speed.
„ To adjust the airflow rate setting
Press .
• Each pressing of
Auto
High
• When the airflow is set to "
from the unit will become quieter.
• In indoor unit quiet operation, the airflow rate is set to a weak level.
• In DRY operation, the airflow rate setting is not variable.
Stop operation
30°
Upper limit
Lower limit
advances the airflow rate setting in sequence.
Indoor unit quiet Low
Middle high Middle
", indoor unit quiet operation will start and the noise
HEAT operation
70°
80°
COMFORT AIRFLOW
Middle low
FAN operation
8°
Upper limit
80°
Lower limit Stop operation
14