Crosley YTW4514 Owner's Manual & Installation Instructions page 12

Getting started
Settings
G
Individual settings for agitation (Soil), water temperature (Temp), and spin (Spin) can be set from the minimum (lowest in
column) to maximum (highest in column) . In general, the higher up the column, the more washer energy will be used .
NOTE: Longer Spin times typically reduce dryer time/energy usage (i .e . reduces total energy when using both a washer and
a dryer) .
Cycle Options
H
Deep Fill
Select the Deep Fill feature for loads where extra water is needed .
loads only, not for typical use .
Press the Deep Fill button once before starting the cycle to add an incremental amount of water to the wash load . Holding the
Deep Fill button for 3 seconds will provide the deepest fill level possible; this will increase cycle time due to the additional time it
takes to fill the washer .
To cancel the option if desired, press the Deep Fill button again .
NOTE: The Deep Fill button can also be pressed after the washer has completed filling and is in the wash phase if additional
water is desired . To stop the extra fill, press the Deep Fill button again and the water will stop .
Warm Rinse
Provides a warm rinse to your wash load . Note that rinsing operations may be different with this operation selected in order to
effectively apply the warm rinse water to your load .
Auto Soak
This option begins with a brief agitation, soaks for a specified period of time, then moves through the rest of the cycle
automatically . Repeated pressing of the Soak button will scroll through 15 minute, 30 minute, 1 hour and 2 hour selections and
then return back to 0 soak minutes .
Deep Rinse
Set this option to provide a deep rinse or when using fabric softener . It may change other settings (e .g . Spin may go to a higher
setting) to maximize performance .
Delay Wash
When the Delay Wash button is repeatedly pressed, the delay time is set from 1 (01H) to 9 (09H) hours and back to clear (00H)
hours . If you press and hold the Delay Wash button for 3 seconds, it will immediately reset .
Extra Rinse
When you use extra detergent or bleach to clean heavily soiled clothes, use the Extra Rinse option to better remove additional
residues . NOTE: This option is not allowed for some cycles .
Additional Options
I
My Cycle Settings
As the cycle selector knob is turned, the Temp, Soil and Spin settings change to automatic pre-set default settings for each
cycle . If you desire different default settings, select the desired options or changes to the cycle settings, then press and hold
the My Cycle button for 3 seconds to store them . The My Cycle button will light when active . In the future, when you
turn the selector knob to that cycle, your settings will be automatically recalled . To restore the factory defaults temporarily
(i .e . for this load), press the My Cycle button for 1/2 second . The My Cycle light will turn off and the factory defaults will
load . However, the next time you select this cycle, your My Cycle settings will load . If you wish to permanently restore the
factory default settings for the cycle; when the My Cycle is active (button light on) press and hold the My Cycle button for 3
seconds . The factory defaults will load for the selected cycle and the My Cycle light will turn off . The default settings will load
when this cycle is selected in the future and the My Cycle light will remain off . NOTE: My Cycle saves the following options:
Temp, Soil, Spin, Extra Rinse, Deep Fill, Warm Rinse, Auto Soak, Deep Rinse and Stain Removal Guide .
Volume (on some models)
Use the Volume button to change the volume of the end of cycle signal and other system tones . Press the button until you reach
the desired volume (high, medium, low) or off .
Control Lock
Use the control lock before or during a cycle to prevent any selections from being made .
To lock/unlock the washer controls, press and hold the Warm Rinse and Auto Soak buttons for 3 seconds . The control lock
icon will light up when it is on . NOTE: The Power button can still be used when the machine is locked .
12
The Deep Fill feature is recommended for special case
49-3000223