Table of Contents
Advertisement
When the countdown is completed, the
programme starts.
The ProSense estimation
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Départ/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Départ Différé button
repeatedly until the display shows
3. Touch the Départ/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Départ/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Départ Différé button
repeatedly until the display shows the
desired delay time.
3. Touch the Départ/Pause button again
to start the new countdown.
12.7 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Départ/Pause button,
the maximum declared load indicator
goes off, the indicator
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
comes on and the indicator
flashes, the drum rotates shortly.
2. The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
At the end of the load detection, in case
of drum overload, the indicator
steady on and the indicator
flashing in the display.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
.
exceeding garments.
Once removed the exceeding garments,
touch the Départ/Pause button to start
the programme again. The ProSense
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
12.8 Programme phase
flashes, the
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
programme duration could increase
or decrease.
At the end of the load detection, if
laundry load is below the maximum
declared weight for selected
programme, the display shows the
new programme duration. After
further 30 seconds, the water filling
starts.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
.
ENGLISH
39
is
is
Advertisement
Table of Contents
