Flex Cable Replacement - TransAct Epic 950 Tech Support Reference Manual

FLEX CABLE REPLACEMENT

Installation:
When installing the cable into the Outer Chassis, make the rear
connection first (A). Then create a loop in the cable so it can be
easily slipped over the clip closest to the connector (B), then repeat
for remaining clips. Release the sliding connector board's latches by
lifting up on the two levers and push the board towards the rear to
allow enough slack to mate the front connection. Now mate the front
connection to the sliding board and pull the sliding board forward
until it is firmly latched.
Description: Flex Cable
TransAct Part Number: 98-06499L
B A
11