Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Encore ENUTV-DAT
Summary of Contents for Encore ENUTV-DAT
- Page 1 ENCORE ENUTV-DAT User Quick Installation Guide...
-
Page 2: Chapter 1: Introduction
Chapter 1: Introduction 1.1 Package Contents Upon receiving your ENUTV-DAT, please make sure the following items are included in the p ackage. E NUTV-DAT device Application Driver CD Quick Installation Guide USB extended cable Antenna PAL to NTSC connector... -
Page 3: System Requirements
1.2 System Requirements • Pentium 4 1.2 GHz or equivalent • M inimum 256 MB memory (512MB DDR RAM recommended) • M inimum 150 MB free hard disk space for program installation • O ne free USB2.0 slot •... -
Page 4: Usage Of Remote Control
1.3 Usage of Remote Control Win 2000/XP Open/Close TV Software Back button Select / Enter button Mute ON / Mute OFF button Number Selections 0 to 9 Switch to the next channel Switch to the previous channel Volume High Volume Low Move Cursor Up button Move Cursor Down button Move Cursor Left button... -
Page 5: Chapter 2: Getting Started
Chapter 2: Getting Started 2.1 Connect the ENUTV-DAT 1. Connect a digital TV antenna cable to the TV Tuner Antenna port. 2. Connect the TV Tuner USB Stick to Computer’s USB port. -
Page 6: Windows Xp
2.2 Device Driver Installation for Windows XP Device Driver & Software Installation for Windows XP To install the ENUTV-DAT to your computer, follow these steps: 3. Once you connect the TV box, just follow the messages to finish the driver installation. - Page 7 2. Wait a few seconds and a new Windows dialogue box will automatically appear on your monitor screen. Select “No, not this time” then click “NEXT” 3. Choose “Install from a list or specific location (Advanced)”. Click “Next” button. 4. Check the “Include this location in the search”...
-
Page 8: Install The Totalmedia™ Software
2.3 Install the TotalMedia™ software. 5. Click “Continue Anyway” button 6. Click “Finish” to end and finish the installation of your new hardware 1. Double click “Setup.exe” from installation 2. Click “Setup Utility” to begin the software installation. - Page 9 3. Click “Yes” button to continue. 4. Click “Next” button or choose setup folder for installation. 5. Click “Next” button.
- Page 10 6. Click “Finish” button to exit. 7. Use remote control or mouse to select TV function. 8. Click “Next” button to continue.
- Page 11 9. Click “Next” button again. 10. Select “Antenna TV” and click “Next” button. 11. Click “Start” button to scan channel automatically. 12. Click “Next” button when scanning finish.
- Page 12 For detailed information and operations of the TotalMedia™ software, please check the TotalMedia™ User’s Manual included in installation CD. 13. Click “OK” to close pop up window. 14. Click “Finish” button. 15. Watch and enjoy your high quality digital...