NEC N6206 User Manual page 12

♦
A wireless device should connect to the antenna by the non-radiation cable (for example coaxial-
cable). The antenna should not be installed near to the human body, except the metal shielding exists
between them, such as metal roof. Only the antenna specially designed for this mobile phone can be
used. The antenna without authorization or with fitting parts refitted or added by users own maybe
damages the mobile phone or violates the related rules, which results in performance decrease or
radiation with unqualified standards.
Effective use
♦
To obtain the best performance with the least power consumption, please pay attention to the
following rules: when talking, please do not use the hand to cover the position of built-in antenna,
which may affect the quality of talking and cause that the mobile phone works with the output power
beyond the normal standard and shorten the talking and idle duration of battery.
Energy of radio frequency
♦
Your mobile phone is a kind of wireless transmitter and receiver with low power. Once the mobile
phone turns on, it will receive and transmit wireless signal intermittently. The network system will
control the transmitting power of the mobile phone.
♦
Your mobile phone also uses the Bluetooth technique. Please see section 12.2.7.1
♦
CAUTION: changes or modifications made in the radio phone, not expressly approved by NEC,
will void the user's authority to operate the equipment.
♦
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: 1) this device may not cause harmful interference, and 2) this device must accept any
interference received, including interference that may cause undesired operation.
SAR information
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. This product has also been
tested against this SAR limit. The highest SAR value reported under this standard during product
certification for use at the ear is 0.659W/kg and when properly worn on the body is 0.080W/kg. This device
was tested for typical body-worn operations with the back of the handset kept 1.5cm from the body. To
maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.5cm
separation distance between the user's body and the back of the handset. The use of belt clips, holsters
and similar accessories should not contain metallic components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be
avoided.
Body-worn operation
To maintain compliance with FCC RF exposure guidelines, if you wear a radio product on your body
when transmitting, always place the radio product in a NEC approved clip, holder, holster, case or body
harness for this product. Use of non-NEC-approved accessories may exceed FCC RF exposure guidelines.
Electromagnetic radiation
♦
Your mobile phone completely complies with the standard on the wireless radiation constituted by
the nation authoritative organization and international health association. These standards of
limitation are a part of the comprehensive rules and compose of permissive standard of public
wireless radiation. These standards are gradually formed through the long-term and in-depth
scientific research conducted by some independent scientific organization ICNIRP (International
N6206 User manual
第 10 页