Operation - Campbell Hausfeld AF011400 Operating Instructions Manual

12-volt inflator
Table of Contents

Advertisement

Available languages

Available languages

OPERATION

Tires
1.
2.
3.
4.
lighter receptacles or fuse will blow and inflator will not work.
5.
6.
7.
8.
9.
10. Do not overinflate tires as tires may rupture/explode causing serious
11. Tire inflation should only be done in a safe area, well off roadway and
Inflatables
1.
2.
3.
Before inflating the tire, review
all warnings listed in the GENERAL
SAFETY INSTRUCTIONS section of this
operating manual.
Remove valve stem cap.
Turn the air hose connector onto the
valve stem in a clockwise direction
until snug (See Figure 2).
Plug power cord into 12-volt DC
power outlet.
To change the unit of pressure between PSI, BAR or KPA, depress
the pressure button (closest to the digital screen) until the desired
measurement is highlighted on the digital screen.
Establish desired inflation pressure by turning the pressure button left
or right until the desired pressure level is identified on the digital screen.
Recommended tire inflation pressure for a vehicle can typically be found
in the vehicle's owner's manual or on the driver's side door jamb.
Press the Power ON / OFF Button to turn the unit on. Inflator will
automatically start to inflate the tire.
Once correct tire pressure is reached, press the Power ON / OFF Button
to turn the unit off and disconnect the air hose connector from the valve
stem.
To insure proper inflation, confirm tire pressure with a separate tire
gauge.
injury and/or property damage.
away from traffic. Use reflective warning triangles and/or safety flares
to alert other drivers of roadside emergency. Always follow the tire
inflation safety advice and procedures noted in the vehicle's operating
manual.
To use the inflation accessories, screw appropriate inflation accessory
into the air hose connector until snug.
Insert the inflation accessory into the inflatable object (tire, football raft,
etc.) and press the Power ON / OFF Button to being the inflation process.
When the object is firm, press the Power ON / OFF Button to turn the
inflator off. Do not over inflate objects as objects may rupture/explode
causing serious injury and/or property damage.
For use with 12-volt DC power outlets rated 15 amps
or higher. Do not use with older 8 amp cigarette
3
Figure 2

Advertisement

Table of Contents
loading

Table of Contents