Setting Up The Handset For Use - Gigaset V300AM Setting Up

V300AM / USA EN / A31008-xxxxx-xxxx-x-6019 / starting.fm / 3.1.08
Connecting the base station
¤
First connect the power adapter and
then the phone jack as shown below
and place the cables in the cable
recesses.
1
1
1
1
1 Underside of the base station (detailed
view)
2 Power adapter 110 V
3 Phone jack with phone cord
Please note:
u
Minimum No. 26 AWG telecommunica-
tion line cord must be used with this
phone.
u
The power adapter must be always
connected, as the phone will not oper-
ate without an electrical connection.

Setting up the handset for use

Inserting the batteries
Caution:
Use only rechargeable UL approved AAA bat-
teries. Never use conventional (non-recharge-
able) batteries or other battery types as this
may cause significant damage to health and
property. For example, the outer casing of the
batteries could be destroyed or the batteries
could explode. The phone could also malfunc-
tion or be damaged as a result of using batter-
ies that are not of the recommended type.
2
3
¤
Fit the batteries with the correct polar-
ity (see diagram).
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤
First align the notches on the side of
the battery cover with the clips on the
inside of the casing.
¤
Then close the cover, press on the top
so that it clicks into place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
First Steps
8