Chevrolet Captiva Owner's Manual page 82

Chevrolet Captiva Owner Manual (GMNA-Localizing-MidEast LHD-
14860584) - 2021 - CRC - 5/18/20
82 Instruments and Controls
On the current operation interface, press
and hold OK to clear the trip mileage 1 and
the average fuel consumption.
After clearing, no average fuel consumption
will be shown until the vehicle has run
for 0.1 km.
Fuel consumed as the vehicle is idling is not
included in the average fuel consumption.
Interface 2 Trip Mileage 2/Total Mileage
The second trip mileage and the total
mileage are shown. On the current
operation interface, press and hold OK to
clear the trip mileage 2.
The total mileage cannot be cleared.
The total mileage matches the general
odometer shown at the lower half of the
liquid crystal display (LCD).
Interface 3 Current Vehicle Speed/
Instantaneous Fuel Consumption
The current vehicle speed indicates the
speed at which the vehicle is currently
running.
Instantaneous fuel consumption
indicates the reference fuel consumption (in
L/100 km) in the current accelerator control
state and under the current driving cycle.
If the current vehicle speed is extremely
low, the instantaneous fuel consumption will
show in L/h (liter per hour).
The instantaneous fuel consumption changes
real-time as the throttle valve opening,
revolution speed, and vehicle load change.
Interface 4 Driving Time/Fuel Range
Calculation of the driving time starts as the
vehicle starts running and ends as the
vehicle stops. The indication can be 23 hours
plus 59 minutes maximum.
After the driving time reaches the maximum
record value, or when the battery gets
disconnected, or the engine flameout
condition lasts for two hours, the driving
time will clear automatically and the
calculation begins again.