Troubleshooting Guide - Emerson NC100RD Important Safety Instructions Manual

NC100RD.OM.QXD 9/13/02
Should this unit exhibit a problem, check the following before seeking service:
Symptom
Radio
Noise or sound distorted
on radio broadcasts.
FM station not heard
in stereo.
AM or FM, no sound.
Compact Disc Player
CD Player will not play.
CD skips while playing.
General
No power.
1:09 PM Page 11

TROUBLESHOOTING GUIDE

Possible Cause
Station not tuned properly for
AM or FM.
FM: Antenna is not properly
adjusted.
AM: Unit is not positioned
correctly.
Poor FM signal being received or
BAND switch is not set to FM.
Station is not broadcasting in stereo.
Function switch is not set to the
RADIO position.
Volume at minimum.
Function switch is not set to the
CD position.
CD is not installed or installed
upside-down.
Disc is dirty or scratched.
Function switch is not set to the
correct position.
AC plug is not inserted properly.
Batteries are not inserted properly.
Batteries are dead or weak.
Solution
Retune the AM or FM broadcast
station.
Reorient FM Antenna.
Rotate unit until best
reception is obtained.
Retune station, try another station or
set the BAND switch to the FM position.
Change stations.
Slide the Function switch to the
RADIO position.
Increase volume.
Set Function switch to the
CD position.
Insert CD with label side up.
Wipe disc with cloth (see page 10 or
use another disc).
Set Function switch to the
correct position, as desired.
Connect AC power cord to AC wall
outlet and jack on rear of unit. Make
sure the plug is inserted securely.
Make sure the batteries are inserted
according to the polarity inside the
battery compartment.
Replace batteries.
11