Special Servicing Tools - Stihl 4144 Series Manual

8.

Special Servicing Tools

New Special Tools
No. Part Name
1 Test flange
2 Sleeve (with 20° chamfer)
3 Puller
Existing Special Tools
No. Part Name
1 Locking strip
2 Carburetor and engine tester
3 Puller
4 Screwdriver
- Setting disk
5 Screwdriver bit
6 Wrench
7 Hook
8 Setting gauge
9 Ignition system tester, ZAT 4
10 Ignition system tester, ZAT 3
11 Puller
- Jaws (No. 3.1 + 4)
- Jaws (No. 2)
- Threaded bushing
12 Press sleeve
13 Hook
14 Press sleeve
15 Installing sleeve
No. Part Name
16 Clamping strap
17 Assembly drift
18 Wooden assembly block
19 Installing tool 8
36
Part No. Application
5910 850 4200 Crankcase leakage test
5910 893 1708 for intstalling tool 8
5910 893 0800 Removing flywheel
Part No. Application
0000 893 5904 Blocking the piston
0000 850 1300 Testing engine and carburetor for leaks
5910 890 4501 Removing limiter caps
5910 890 2305 Adjusting carburetor with limiter cap
5910 893 6600 Add-on for screwdriver (adjusting
carburetor)
0812 540 1112 Removing and installing spline socket
screws with electric or pneumatic
screwdrivers; tighten down screws with
torque wrench, releasing clutch drum
4130 890 3600 Loosening clutch
5910 890 2800 Detaching springs on clutch shoes
1127 890 6400 Adjusting air gap between the ignition
module and flywheel
5910 850 4503 Testing ignition system
5910 850 4520 Testing ignition system
5910 890 4400 Removing oil seals
0000 893 3706 Removing oil seal(s)
0000 893 3700 Holding engine pan on crankcase
1108 893 4500 Preparing puller
1129 893 2400 Installing oil seals
5910 893 8800 Removing pickup body
1121 893 2400 Installing oil seals
4119 893 4600 Protects oil seal at starter side
Part No. Application
0000 893 2600 Clamping ring around piston
1130 893 4700 Removing and installing piston pin
1108 893 4800 Supporting the piston
5910 890 2208 Installing hookless snap rings in piston
Rem.
Rem.
Rem.
Series 4144 Powerhead