Vcr Setup - LG 42LC2D Series Owner's Manual

VCR SETUP

- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of
the screen may remain visible on the screen.
1. When connecting with an antenna
ANTENNA
OUT
ANTENNA
IN
ANTENNA
Back panel of the set
OUT
ANTENNA
IN
2. When connecting with a RCA cable
VCR
OUT S-VIDEO
(R) AUDIO (L) VIDEO
OUTPUT
SWITCH
3 4
IN
1
VIDEO AUDIO S-VIDEO
( )
VIDEO VIDEO AUDIO S-VIDEO
( )
MONO
!
NOTE
If you have a mono VCR, connect the audio cable from the VCR to the A A U U D D I I O O L L / / M M O O N N O O jack of the set.
G G
VIDEO AUDIO S-VIDEO
( )
VCR
ANT IN
ANT OUT S-VIDEO OUT
(R) AUDIO (L) VIDEO
OUTPUT
SWITCH
3 4 IN
1
ANT IN
ANT OUT
COMPONENT IN
Back panel of the set
VIDEO
AUDIO
COMPONENT IN
VIDEO
AUDIO
COMPONENT IN
VIDEO
AUDIO
1
Connect the RF out socket of the VCR to the
Antenna socket on the set.
2
Connect the antenna cable to the RF antenna
socket of the VCR.
3
Press the PLAY button on the VCR and match
the appropriate programme between the TV
and VCR for viewing.
1 AUDIO/VIDEO
Connect the
and VCR. Match the jack colors (Video = yel-
low, Audio Left = white, and Audio Right = red)
2 Insert a video tape into the VCR and press
PLAY on the VCR. (Refer to the VCR owner's
manual.)
3 AV3
Select input source using the
ton on the remote control.
- If connected to AV
source.
jacks between TV
INPUT
but-
IN4, select AV4 input
17