Name Of Parts - Fujitsu ASY9ASSCW Operating Manual

NAME OF PARTS

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 Indicator Lamps (Fig. 3)
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
G
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 13 Auto Restart).
7 SWING Indicator Lamp (orange)
8 Intake Grille (Fig. 4)
9 Air Filter
0 Air Flow Direction Louver
A Right-Left Louver
(behind Air Flow Direction Louver)
B Drain Hose
C Power Supply Plug
D Power Supply Cord
E Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
F Intake Port
G Outlet Port
H Pipe Unit
En-3
Fig. 6 Remote Control Unit
I SLEEP button
J MASTER CONTROL button
K SET TEMP. button (
L Signal Transmitter
M OFF TIMER button
N ON TIMER button
O SET TIMER button
P CANCEL TIMER button
Q FAN CONTROL button
R START/STOP button
S AIR FLOW DIRECTION button
T SWING LOUVER button
U ACL button
V TEST RUN button
G This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner's thermostat function to op-
erate incorrectly.
G If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit's OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
G To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
W Remote Control Unit Display (Fig. 7)
X Transmit Indicator
Y Operating Mode Display
Z Timer Mode Display
OFF TIMER Mark:
ON TIMER Mark:
SLEEP TIMER Mark:
[ Fan Speed Display
\ Te m p e r a t u r e a n d t i m e d i s p l a y
It displays the temperature setting. How-
ever, when making the Timer setting, it will
display the Timer time. (The temperature
setting will reappear after finishing the
timer setting)
/ )