120 Volt Ac Charging - Husky HSK012HD User's Manual & Warranty Information

HSK012HD MAN ENGL 090105
WARNING:
• Always use protective eyewear when using this product: contact with battery acid
may cause blindness and/or severe burns.
• Keep out of children's reach.
FIRST AID:
SKIN: If battery acid comes in contact with skin, rinse immediately with running water,
then wash thoroughly with soap and water. If redness, pain or irritation occurs,
seek immediate medical attention.
EYES: If battery acid comes in contact with eyes, flush eyes immediately - for minimum
of 15 minutes - seek immediate medical attention.
CHARGING/RECHARGING
For maximum battery life, we recommend the Husky
System be kept fully charged at all times. If the battery is allowed to remain in a dis-
charged state, battery life will be shortened.
NOTE: Recharging battery after each use will prolong battery life; frequent
discharges between recharges will reduce battery life.
Charge up to 48 hours to reach full charge.
IMPORTANT: MAKE SURE ALL SWITCHES ARE TURNED OFF DURING
RECHARGING.

120 Volt AC Charging

Charge unit for full 48 hours using AC method, prior to first use
Recharge unit fully after each use
1. Simply plug the AC plug of the AC/DC adapter/charger into any standard 120
volt AC wall outlet.
2. Plug the barrel connector attached to the AC adapter/charger into the small bar-
rel receptacle on the jump-starter that is marked recharge port.
3. When charging is completed and the FULL light is on, remove the AC/DC charg-
er plug and store in a safe place.
NOTE: The unit cannot be overcharged using the AC method. The Husky
ELITE Jump-Start System also comes with a DC/DC charging adapter for
®
recharging the unit from a 12 volt DC accessory outlet in a vehicle or boat.
WARNING: Do not recharge for more than 4-5 hours maximum using 12 volt DC
method
7
9/1/05 5:42 PM Page 7
AC ADAPTER/CHARGER
™ START-IT ELITE ® Jump-Start
START-IT
™