Position Input For "Motion Control" Technology Object; Configuring - Siemens SIMATIC S7-1500/ET 200МР Manual

4.2

Position input for "Motion Control" technology object

4.2.1

Configuring

Introduction
You configure the technology module and assign its parameters with STEP 7 (TIA Portal).
The technology object is used to control and monitor the functions of the technology
module.
System environment
The technology module can be used in the following system environments:
Applications Components required
Central operation
•
with an S7-1500 CPU
•
Distributed operation
•
with an S7-1500 CPU
•
•
Additional information
You can find a detailed description of the use of Motion Control and its configuration in the
following:
• Function manual S7-1500 Motion Control available for download on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/59381279)
• Function manual S7-1500T Motion Control available for download on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/109481326)
• Information system of STEP 7 (TIA Portal) under "Using technology functions > Motion
Control > Motion Control (S7-1200, S7-1500)"
You can find a description of configuring the technology module for position detection in the
following:
• Function manual Counting, Measurement and Position Detection available for download
on the Internet (http://support.automation.siemens.com/WW/view/en/59709820)
• Information system of STEP 7 (TIA Portal) under "Using technology functions > Counting,
measurement and position input > Counting, measurement and position input (S7-1500)"
Technology module TM Count 2x24V (6ES7550-1AA01-0AB0)
Equipment Manual, 12/2020, A5E31870371-AC
S7-1500 automation system
TM Count 2x24V
S7-1500 automation system
ET 200MP distributed I/O sys-
tem
TM Count 2x24V
4.2 Position input for "Motion Control" technology object
Configuration software
STEP 7 (TIA Portal):
• Device configuration with
hardware configuration
• Parameter setting with axis
and measuring input technol-
ogy objects
Configuring/address space
In the user program
Motion Control instructions
31