Advertisement
FINAL ASSEMBLY
See Figure 6-19. Place the PC board on the top case so that the ringer switch is in the ringer switch hole,
the tone/pulse switch is in the tone/pulse hole and the two mounting holes on the PC board line up with the
mounting posts on the top case. If the the PC board does not stay lined up with the two mounting posts,
insert one or both of the 5/8" screws to keep it in place. Check the following:
a) Be sure that the speaker wires do not lay between the speaker and the telephone top case.
b) Be sure that the keyboard ribbon cable is in the notch in the side of the PC board and does not extend
out over the edge of the top case.
c) Make sure that no leads from the PC board touch the 1/4" screws mounting the keypad.
d) Be sure that the keyboard PC board does not hit the buzzer.
Loop the telephone cord through the strain relief tabs on the bottom case as shown in the Figure 6-19.
Place the bottom case over the top case. Be sure that the telephone cord is in the notch at the base of the
bottom case. Snap the bottom case in place and secure it with two 5/8" screws as shown in Figure 6-19.
The telephone number label with its cover mounts over the two 5/8" screws. Insert the tabs at each end of
the label into the slots along side the screws.
If you are doing the testing with a 9V battery, skip to Section 7 now.
Mounting Post
5/8" Screws
-26-
Figure 6-19
Advertisement
