Advertisement
PC BOARD ASSEMBLY
Identify and install the following parts as shown in Figure 6-1. After soldering each part, place a check in the
box provided.
R3 - 47kΩ Resistor
(yellow-violet-orange-gold)
R4 - 47kΩ Resistor
(yellow-violet-orange-gold)
LP4 - Neon Bulb
LP3 - Neon Bulb
(see Figure A)
R5 - 10kΩ Resistor
(brown-black-orange-gold)
C1 - .47µF Mylar Cap. (474)
(see Figure B)
R6 - 100kΩ Resistor
(brown-black-yellow-gold)
Q1 - 9014C Transistor
(see Figure C)
R7 - 2.2kΩ Resistor
(red-red-red-gold)
R14 - 150kΩ Resistor
(brown-green-yellow-gold)
LP1 - Neon Bulb
(see Figure A)
R1 - 47kΩ Resistor
(yellow-violet-orange-gold)
T - Jumper Wire
R - Jumper Wire
(see Figure D)
R2 - 47kΩ Resistor
(yellow-violet-orange-gold)
LP2 - Neon Bulb
(see Figure A)
Figure 6-1
Figure C
Mount the transistor with the
flat side in the same direction
as marked on the PC board.
1/16"
-11-
Figure A
Mount the neon bulb as
shown with the bulb in the
same direction as marked on
the PC board.
Give about
a 1/8" space between the bulb
and the holes in the PC
board.
1/8"
Figure B
Mount the mylar capacitor flat
against the PC board as
shown.
Leave about 1/4"
space between the capacitor
and the PC board holes as
shown. Solder and twist the
leads together. DO NOT CUT
THE LEADS.
1/4"
Note: Make sure
that these leads
do not touch.
Twist the
leads.
Figure D
Use a discarded resistor lead
for a jumper wire.
Leave
about a 1/16" space between
the jumper and the PC board.
1/4"
1/16"
Advertisement
