Advertisement
3. Install the Fan
Position the fan all the way to the rear and center in the
appliance. Press the fan (magnets to the bottom) to the
back of the appliance. See Figure 7. Plug the fan cord
into the fan receptacle labeled "FAN" on the junction box.
See Figure 8.
4. Install the Control Module
Attach the control module to the bottom pan using the mag-
netic tape provided.
5. Wiring the Fan Control Module
Note: Fan control timer only for use on units with junction
box pictured in Figure 9.
•
Robertshaw Valve (Standing Pilot)
-
Connect the black, white and red wires with 1/4 in.
female connectors from the fan control module to the
appliance junction box as shown in Figure 9.
-
Connect the black ground wire with the ring terminal
to the TP screw on the valve (center).
-
Remove wall switch wire connected to valve terminal
marked "TH".
-
Connect the black with white stripe wire with 3/16 in.
piggyback connector from fan control module to valve
terminal marked "TH".
-
Connect wall switch wire removed from valve terminal
"TH" to the piggyback connector on the black with white
stripe fan control module wire.
Note: Thermopile must be wired as shown in Figure 9.
RS
Valve
Figure 9
Robertshaw Wiring Diagram
Fan
Control
Module
Hearth & Home Technologies • GFK4B Fan Kit • 4016-095 Rev N • 04/21
FIREBOX
BOTTOM
FAN
BOTTOM PAN
Figure 7
Rotate Fan
Fan Assembly
Junction Box
Figure 8
Position the Fan
Wall
Switch
White
Red
Black
APPLIANCE
BACK
Cord
Clips
3
Advertisement
