Table of Contents
Advertisement
PRODUCT
IDENTIFICATION
Ignitor Button
Heater
Cabinet
Log
Figure 1 - Vent-Free Gas Log Propane/LP Gas Space Heater
ASSEMBLY
ASSEMBLING HEATER
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
Removing Front Panel Of Heater
1. Remove two screws near bottom cor-
ners of front panel with Phillips screw-
driver.
2. Pull bottom of front panel forward, then
down (see Figure 2) .
Figure 2 - Removing Front Panel of Heater
106055
Note: Do not remove
Lighting and Warning
Plates from heater
Control Knob
Lighting and
Warning Plates
Screen
Front
Panel
Installing Log
Note: For easier installation, lay heater on
its back.
1. Remove log from inside top of heater.
Discard protective packaging.
2. Attach ignitor cable to piezo ignitor
(see Figure 3).
3. With Phillips screwdriver, remove four
screws holding screen in place. Re-
move screen.
Piezo Ignitor
Figure 3 - Attaching Ignitor Cable to Piezo
Ignitor
3
OWNER'S MANUAL
UNPACKING
CAUTION: Do not remove the
metal data plates attached to the
heater base assembly. The data
plates contain important warranty
information.
1.
Remove heater from carton.
2. Remove all protective packaging ap-
plied to heater for shipment.
3.
Make sure your heater includes two
hardware packets.
4. Check heater for any shipping damage.
If heater is damaged, promptly inform
dealer where you bought heater.
4.
Gently slide log between log retaining
brackets on deflector assembly (see
Figure 4, page 4). The log should fit
firmly against bottom of log retaining
brackets.
5.
Reattach screen using four screws re-
moved in step 3.
Ignitor
Cable
Continued
Advertisement
Table of Contents
