Table of Contents
Advertisement
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
If you touch the Start/Pauze button,
the appliance performs the only
draining phase.
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the drain-only option
(Skipping the wash, rinse and spin
phases): Only drain.
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator
spin) and the indicator
• Activate the spin-only option
(Skipping the wash and rinse
phases): Only spin.
Before setting this option,
select a suitable washing
programme for the
garments. The appliance
will performs the most
fitting spin cycle for your
garments care (e.g. For
synthetics items, first
select the Synthetica
washing programme and
then the Only spin
option).
The appliance performs only the
spinning phase of the selected
washing programme.
The display shows the indicator
(cold), the phase indicator
spin speed.
8.5 Vlekken/Voorwas
Press this button repeatedly to activate
one of the two options or both.
The relevant indicator goes on in the
display.
• Vlekken
Select this option to pre-treat heavily
soiled or stained laundry using stain
remover.
Pour the stain remover into
compartment
is pre-mixed and heated with
detergent in order to improve its
effectiveness.
• Voorwas
Use this option to add a prewash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
(no
.
8.6 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The indicator
during steam phase.
When the programme stops the display
shows a zero
steady on and the indicator
flashing, and the Start/Pauze led remains
lit. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
and the
button the anti-crease movements stop
and the door unlocks, the appliance
proposes again the previous set
programme.
To interrupt the anti-crease phase, you
can also:
. The stain remover
This option is not
available with a
temperature lower than
40 °C.
The options can increase the
programme duration.
flashes on the display
This option can increase the
programme duration.
, the indicator
ENGLISH
17
is
starts
Advertisement
Table of Contents
