Optional Gas Line Installation - Superior Fireplaces WRT6036 Installation And Operation Instructions Manual

Indoor wood-burning fireplace
Table of Contents

Advertisement

Gas line hook up should be done by your supplier or a qualified
service person.
Note: Before you proceed, make sure your gas supply is turned off.
Use only a 1/2" black iron pipe and appropriate fittings.
1. Remove knockout indentation on refractory or firebrick wall lo-
cated above refractory hearth floor. Knockout indentation must be
firmly tapped with any solid object such as a 1/2" dowel until it is
released. Remove fragmented portions of refractory (see Figure
37).
2. Remove gas line cover plate located on either side of fireplace and
pull out insulation from gas line conduit sleeve. Save insulation for
reuse. Replace screws.
3. Run a 1/2" black iron gas line into fireplace through the rear at gas
line conduit sleeve (if using a raised platform, add height). Provide
sufficient gas line into fireplace chamber for fitting connection (see
Figure 38, page 19).
Note: Secure incoming gas line to wood framing to provide rigidity for
threaded end.
4. Repack insulation around gas line and into sleeve opening. Seal any
gaps between gas line and refractory knockout hole with refractory
cement or commercial furnace cement, Install the gas appliance or
cap-off gas line if desired.
18

OPTIONAL GAS LINE INSTALLATION

tested for leaks after the installation is completed.
After ensuring that the gas valve is on, apply soap and
water solution to all connections and joints. Bubbles
forming show a leak. Correct all leaks at once. DO NOT
USE AN OPEN FLAME FOR LEAK TESTING AND DO NOT
OPERATE ANY APPLIANCE IF A LEAK IS DETECTED.
LEAK TESTING SHOULD BE DONE BY A QUALIFIED
SERVICE PERSON.
this fireplace with the chimney removed.
Gas Conduit
Cover
SuperiorFireplaces.us.com
CAUTION: All gas piping and connections must be
WARNING: Do not operate an unvented gas log set in
Outside of
Fireplace
Gas Line
Remove
Conduit
Knockout
Insulation
Figure 37 - Gas Line Access
Side
Firebrick
Finished
Side
1/2" Dowel
Brick with
Access Hole
901007-00_NC

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wrt6042Wrt6050

Table of Contents