Table of Contents
Advertisement
Chapter 1 GENERAL DESCRIPTION
4-1-3
How to Set Production Counter (In the case of LC48)
panel front figure
014C-PS009
standard setting
input mode DOWN
output mode HOLD A
30/1K both of them is OK.
If you UP the counter, OP will be represented and the production finish signal will be output.
When production finished, the red lamp turns on and the next process stop immediately.
If you want to restart the machine, press reset switch of the counter and then press the line
start switch which on the forward stoker operation panel.
Make sure that all of production process are stopped when you restart the machine.
013C-E-OMA04-A01-01
Section 4 BASIC OPERATION
Set the number of boards
• Press ENTER .
• Press ← to move "-" to the
position of number which you want
to set it.
• Press SET to enlarge the
number, if it is over 9 it goes back
to 0 .
• If you finish setting, press RESET .
Mode setting
• Press ENTER .
• If you want to set input mode,
"DOWN", keep pressing
INPUT M till "DOWN" is
represented.
• Press RESET .
• If you want to switch to the output
mode, press OUTPUT H .
4
Page 4-3
Advertisement
Table of Contents
