Panasonic SA-PT875GA Service Manual page 88

FP8101 to CN2001).
Step 16 Remove the front panel assembly.
Step 17 Position Main P.C.B. according to the diagram shown.
Step 18 Turn the Front Panel Assembly and position it accord-
ing to diagram shown.
Step 19 Connect 14P cable at the connector (CN6003) on Main
P.C.B.
Step 20 Connect 7P cable at the connector (CN2010) on Main
P.C.B.
Step 21 Connect 19P cable at the connector (CN2007) on Main
P.C.B.
Step 22 Attach original cable with extension cable REXX0653-
J (14P cable from H2901 to CN2016).
Step 23 Attach original cable with extension cable REXX0724
(8P cable from H2900 to CN2017).
Step 24 Attach original cable with extension cable REXX0725
(8P cable from H5801 to CN5500).
Step 25 Remove 6 screws on SMPS P.C.B.
Step 26 Release SMPS P.C.B Spacer.
Step 27 Remove 2 screws on AC Inlet Shield Plate Unit.
Step 28 Remove AC Inlet Shield Plate Unit.
Caution: Keep the AC Inlet shield plate unit in safe place.
Avoid denting it. Place it back during assembling.
Step 29 Remove 1 screw at the rear panel.
Step 30 Release the tab of the rear panel in the direction of
arrow.
88