Advertisement
Quick Links
John Lewis
King
Thank you for purchasing this Resto Bedstead. Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product.
Pre-assembly Preparation
Please ensure instructions are read in full before attempting to assemble this product.
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the John Lewis Helpline.
HEAVY
This product is
WHEN LIFTING
to avoid personal injury and (or) damage to the product.
This product takes approximately
The fittings pack contains
CHILDREN
.
Read this leaflet in full before commencing assembly.
If you require any additional information or have any issues with this product please call the John Lewis
Helpline on 01244 - 689949 or e-mail: mail@fwgroup-uk.com
Resto Bedstead
. It should be assembled as near as possible to the point of use.
40 MINUTES
SMALL PARTS
For product support or spare parts
please call the John Lewis Helpline;
Tel:01244 - 689949
e-mail:mail@fwgroup-uk.com
2 PEOPLE
to assemble with
KEPT AWAY FROM YOUNG
which should be
Stock number black: 803/44911
Stock number cream: 803/45031
TAKE CARE
.
Advertisement
Related Manuals for John Lewis Resto Bedstead
Summary of Contents for John Lewis Resto Bedstead
- Page 1 The fittings pack contains which should be CHILDREN Read this leaflet in full before commencing assembly. If you require any additional information or have any issues with this product please call the John Lewis Helpline on 01244 - 689949 or e-mail: mail@fwgroup-uk.com...
- Page 2 Fitting and parts checklist Wooden Slats x 28 M6 x 25mm Bolt M6 x 30mm Bolt M6 x 35mm Bolt M6 Nut x 6 Centre Plastic Holder x 14 M6 Lock Nut x 4...
- Page 3 Step by step assembly instructions Step One Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using Washer (A) and M6 x 25mm Bolt (B). Tighten using Allen Key (J) as shown in the diagram below. Repeat this for all 4 corners. Step Two Place the Cross Bars (5) onto the Side Rails (3) and secure using M6 x 30mm Bolt (C) and M6 Nut (E).
- Page 4 Step Three Ensuring the holes along the Centre Rail (7) are facing upwards, attach to the underside of the Cross Bars (5) using M6 x 35mm Bolt (D). Screw the Adjuster (F) fully into the bottom of the Supporting Legs (6). Attach the Supporting Legs (6) into the pre - drilled holes on the underside of the Centre Rail (7) using M6 x 35mm Bolt (D) and M6 Lock Nut (I) as shown in the below diagram.
- Page 5 This product complies with BS 1725:1998...