Table of Contents
Advertisement
Quick Links
Apollo
SRX400 Installation Instructions
™
Important Safety Information
WARNING
Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor
product performance.
See the Important Safety and Product Information guide in the product box for product warnings and other
important information.
This device must be installed according to these instructions.
Disconnect the vessel's power supply before beginning to install this product.
Before applying power to this product, make sure it has been correctly grounded according to these
instructions.
CAUTION
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
Do not use the stereo as a template when drilling the mounting holes because this may damage the glass
display and void the warranty. You must only use the included template to correctly drill the mounting holes.
You must read all installation instructions before beginning the installation. If you experience difficulty during
the installation, contact Fusion
®
Product Support.
What's In the Box
• Mounting gasket
• Mounting template
• Four 8-gauge, self-tapping screws
• Two screw covers
• Power, speaker, line-out, and subwoofer-out wiring harness
Tools Needed
• Phillips screwdriver
• Electric drill
• Drill bit (size varies based on surface material and screws used)
• Rotary cutting tool or jigsaw
• Silicone-based marine sealant (optional)
May 2021
GUID-FF0E2FF3-6582-49AF-A641-C26455B2A8CF v5
Advertisement
Table of Contents
Related Manuals for Garmin Fusion Apollo SRX400
Summary of Contents for Garmin Fusion Apollo SRX400
- Page 1 Apollo SRX400 Installation Instructions ™ Important Safety Information WARNING Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor product performance. See the Important Safety and Product Information guide in the product box for product warnings and other important information.
-
Page 2: Mounting Considerations
Mounting Considerations • You must mount the stereo on a flat surface that provides open airflow around the rear of the stereo for heat ventilation. • If you are installing the stereo in a location that may be exposed to water, you must mount it within 45 degrees of the horizontal plane. -
Page 3: Mounting The Stereo
Mounting the Stereo NOTICE Do not use the stereo as a template when drilling the mounting holes because this may damage the display and void the warranty. You must only use the included template to correctly drill the mounting holes. Be careful when cutting the hole to mount the stereo. -
Page 4: Port Identification
Port Identification Connects to a Fusion PartyBus stereo or network (Fusion PartyBus Networking, page 10). FUSE Contains the 15 A fuse. Connects to a typical AM/FM antenna. If you are installing the stereo on a boat with a metal hull, you must use a ground-dependent antenna. -
Page 5: Wiring Harness
Wiring Harness Wire Color/ Wire Function Notes Label Ground (-) Black Connects to the power source (Power Connection, page Power (+) Yellow Connects to the power source (Power Connection, page Ignition Connects to the power source (Power Connection, page Connects to an optional external amplifier to turn on he amplifier when the stereo turns on. -
Page 6: Power Connection
Power Connection When connecting the stereo to power, you must connect the yellow, red, and black wires to the power source. The yellow and red wires have different functions, and the method you use to connect them to power depends on how you plan to use the stereo on your vessel. - Page 7 Connecting to Power Without Using an Ignition Switch This method of connection is used most often on larger vessels and on vessels with multiple networked stereos and other marine devices. For these installations, a faster startup time is typically less critical, and it is more effective to use the breaker or a dedicated switch on the electrical panel to turn off the stereo and ensure that no unexpected power drain occurs.
- Page 8 Connecting to Power Through an Ignition Switch This method of connection is used most often on ski boats, wake boats, and similar sport or recreational vessels where power to the engines is toggled often. For these installations, a quick standby and faster startup time is desired so that music can be stopped and begin playing again as quickly as possible after restarting the engines.
- Page 9 Speaker System Wiring Using the Internal Stereo Amplifier Speakers Water-tight connection Speaker System Wiring Using the Line Out Item Description Speakers Powered amplifier Line out and subwoofer out The subwoofer cable provides a single mono output to a powered subwoofer or subwoofer amplifier. You may need to use an RCA splitter to connect this to an amplifier.
- Page 10 Fusion PartyBus Networking The Fusion PartyBus networking feature allows you to connect multiple compatible stereos together on a network, using a combination of wired or wireless connections. You can group a compatible stereo, such as the Apollo RA770 stereo, with other compatible stereos connected to the network.
- Page 11 Wired Network Example with a Switch or Router You must use wired network switches, a wired network router, or both to connect more than two devices. If you did not install a router, and there are no other DHCP servers on the network, you should configure one Fusion PartyBus stereo to be a DHCP server (Setting the Fusion PartyBus Device as the DHCP Server, page 14).
- Page 12 Wireless Access Point Example Fusion PartyBus stereo Fusion PartyBus zone stereo Smartphone using the Fusion-Link app Wireless Network Example with a Wired Switch or Router Fusion PartyBus stereo Wired network switch or wired network router Fusion PartyBus zone stereo or remote control Fusion PartyBus zone stereo Smartphone using the Fusion-Link app.
- Page 13 Wireless Network Example with a Wireless Router or Access Point Fusion PartyBus stereo Wireless network router or wireless access point Fusion PartyBus zone stereo or remote control Fusion PartyBus zone stereo Smartphone using the Fusion-Link app Apollo SRX400 Installation Instructions...
-
Page 14: Constructing A Network
Constructing a Network You should have a basic understanding of networking when building a network for Fusion PartyBus devices. These instructions guide you through the basics of building and configuring a network, and should apply to most situations. If you need to perform advanced networking tasks, such as assigning static IP addresses to devices on the network or configuring advanced settings on a connected router, you may need to consult a networking professional. - Page 15 Marine Network ® You can connect this stereo to a Garmin Marine Network in order to view and control the stereo using a compatible Garmin chartplotter. NOTE: When you configure the stereo for use with a Garmin Marine Network, you are limited to using only Garmin and Fusion devices.
-
Page 16: Network Troubleshooting
Network Troubleshooting If you cannot see or connect to Fusion PartyBus devices on the network, check the following: • Verify that only one device, either a stereo or a router, is configured as a DHCP server. • Verify that all Fusion PartyBus devices, network switches, routers, and wireless access points are connected to the network and turned on. - Page 17 Stereo Information Specifications General Weight 340 g (12.0 oz.) Water resistance IEC 60529 IPX7 (front of stereo only, when properly installed) Operating temperature range From 0 to 50°C (from 32 to 122°F) Storage temperature range From -20 to 70°C (from -4 to 158°F) Input voltage From 10.8 to 16 Vdc Current (max.)
-
Page 18: Stereo Dimension Drawings
Stereo Dimension Drawings Side Dimensions 110 mm (4.33 in.) 100 mm (3.94 in.) 70 mm (2.76 in.) 50 mm (1.97 in.) Top Dimensions 83 mm (3.27 in.) 22 mm (0.87 in.) 10 mm (0.39 in.) 110 mm (4.33 in.) Apollo SRX400 Installation Instructions... -
Page 19: Software Updates
Software Updates Go to support.garmin.com to find software updates and information for your device. 連絡地址 製造銷售:台灣國際航電股份有限公司 聯絡地址:新北市汐止區樟樹二路 68 號 電 話:(02)2642-8999 客服專線:(02)2642-9199 Apollo SRX400 Installation Instructions... - Page 20 © 2018–2021 Garmin Ltd. or its subsidiaries support.garmin.com...