Natural Gas Conversion - KitchenAid KSDB900ESS Owner's Manual

Hide thumbs Also See for KSDB900ESS:
Table of Contents

Advertisement

Available languages

Available languages

5. Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
Propane gas orifice spud.
A. Propane groove
Refer to the following chart for correct Propane gas orifice
spud ratings and to spud holder card for proper placement.
Fully insert choke into bottom of large burner base. Choke
should snap into place.
NOTE: Use only for speader bases marked "L"
Propane Gas Orifice Spud Chart for Surface Burners.
Placement
Burner
Rating/Type
15,000 BTU
LF (ST)
1,450 BTU
LR
5,000 BTU
RF
14,200 BTU
RR
8,000 BTU
CTR
8,000 BTU
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door for
proper sizing of spuds for each burner location.
6. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case of
reinstallation with Natural gas.
7. Replace the burner base.
8. Replace burner cap.
9. Repeat steps 1 to 7 for the remaining burners.
10. Replace the baking drawer. See the "Remove/Replace
Drawer" section.
Complete Installation (Natural Gas to Propane
Gas)
1. Refer to the "Make Gas Connection" section for proper
connection of the range to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition and operation.
3. Refer to the "Adjust Flame Height" section for burner flame
adjustments.
IMPORTANT: You may have to adjust the low setting for each
cooktop burner.
Checking for proper cooktop burner flame is very important.
Natural gas flames do not have yellow tips.
4. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
IMPORTANT: Make sure to save the orifices that have just been
replaced in the conversion.
26
Size (mm)
ID Number
1.08
108AM
0.35
035AM
0.64
064AM
1.08
108AM
0.84
084AM
0.84
084AM

Natural Gas Conversion

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
1. Turn manual shutoff valve to the closed position.
A. To range
B. Shutoff valve (closed position)
C. Gas supply line
2. Unplug range or disconnect power.
To Convert Gas Pressure Regulator (Propane Gas
to Natural Gas)
1. Move the range out about 1 ft (30.5 cm) from the wall.
2. Locate the gas pressure regulator at the lower right corner on
the back of the range.
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents