Mattel HYPER SCAN Instructions Manual page 8

SCAN BATTLE RESCAN
Problem:
The controller will not work properly
Problem:
Game disc does not play.
Solution(s)
• Make sure the power is off before plugging any
controllers into the console.
• Insert the Controller plug completely into the
Controller socket on the front of the console.
• Read the instruction booklet for the game you
are playing to make sure you are using the
correct Controller socket.
• Make sure that no control buttons are depressed
and the control stick is in the neutral position
when you turn the power on.
• Make sure you are using a HyperScan
™
controller.
Solution(s)
• Make sure you are playing a HyperScan ™
game disc.
• Check that the game disc label is facing up in
the game disc player and that the game disc
player lid is closed. Do not touch the laser lens.
• Make sure the disc is clean. See page 6 for
cleaning instructions.
SCAN BATTLE RESCAN
Problem:
The HyperScan console is not reading a
™
HyperScan game card.
™
Solution(s)
• Make sure you place the game card at least
1/2 inch from the Hyper Scan ™ sensor on the
console. The card might not scan if it is held too
far away. You will hear a sound confirming that
the card has been deciphered/accepted.
• Make sure the character picture on your
Hyper Scan Game Card is facing down when
™
you scan it.
• Check the Hyper Scan Game Card for
™
damage. Bending a card may cause damage,
preventing it from functioning correctly.
• Read the game instructions and make sure you
are scanning the Hyper Scan ™ Game Card for
that game.
If you are experiencing additional
problems or difficulties with your
Hyper Scan system, please visit our
™
web site at
www.HyperScanGamer.com and go
to the Trouble Shooting section.