Trouble Shooting With Error Code - LG WTG7532W Service Manual

4-5. TROUBLE SHOOTING WITH ERROR CODE

ERROR DECISION
ERROR
・ WATER LEVEL
WATER
SUPPLY dose not rise to
the set level in within
30 minutes.
lamp blinks
・ Water is not
DRAINAGE
completely drained
within 12 minutes.
・ Laundry
UNBALANCE
unbalance during
spin.
・ LID is opened in
LID
OPEN the course of
intermittent spin,
normal spin or
processing
reservation.
BASIS
・ Water faucet is closed?
・ Water supply is interrupted.
・ Inlet valve is clogged with
dirts.
・ Connector has bad contact
NO INLET
to the inlet valve.
・ RED 6-pin connector has
a bad connection at the main
board.
・ Is the drain hose located
properly?
・ Drain hose is folded or
clogged due to freeze or dirt.
・ Defective drain pump or the
WHITE 6-pin connector to the
main board has a bad
connection.
・ Laundry in the INNER TUB
is filled unevenly.
・ Washer is tilted.
・ Lid is opened during
intermittent spin or normal
spin?
・ Lid is opened while
processing reservation?
・ Check the connections to the lid
switch and at the WHITE 6-pin
connector at the main board.
CAUSE FOR ERROR
OCCURRENCE
40
REMEDY
・ Open water faucet.
Wait until water supply is
resumed.
・ Clean or replace filter.
・ Correct the connector
contact.
・ Same as above.
・ Drain hose properly positioned
at 0.9 ~ 1.2 m (36 ~ 48 inches)
above the floor.
・ Make sure the drain hose is not
plugged with a foreign object.
・ Check drain pump motor
contact. Replace the pump if
necessary.
・ Load the washer as evenly as
possible.
・ Adjust the leg.
・ Close the lid.
・ Close the lid.
・ Check the connections.
・ If the connection is good, check
the lead wire and replace it if
necessary.