Table of Contents
Advertisement
3-4 Jumper Setting
(1) KB/MS Power on Function Enabled/Disabled: JP1
(2) CMOS RAM Clear (3-pin): JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM.
Note: When should clear CMOS
1.
Troubleshooting
2.
Forget password
3.
After over clocking system boot fail
WARNNING! Please remove or turn off the power supply before CMOS clear.
Following these steps to clear CMOS:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JBAT and short pins 2-3 for a few seconds
4.
Return JBAT to its normal setting by shorting pins 1-2
5.
Connect ATX power cable back to ATX power connector
JP1
1-2 Closed: KB/MS Power ON Disable (Default)
Keyboard /Mouse Power On Setting
JBAT
1-2 Closed Normal
JP1
2-3 Closed: KB/MS Power ON Enabled
JBAT
2-3 Closed
CMOS RAM Clear Setting
14
clear Cmos
Advertisement
Table of Contents
