Electrical Parts - LG LW5012 Service Manual

6. MOTOR
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section 2)
4. Remove the control panel. (Refer to Section 3)
5. Remove the air guide upper. (Refer to Section 4)
6. Remove the compressor, turbo fan, axial fan and
shroud. (Refer to Section 5)
7. Remove 4 screws that secure the motor to the mount
motor of shroud. (See Figure 22)
8. Remove the motor.
9. Re-install by referring to the procedures above.
7. AIR GUIDE LOWER AND SHROUD
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section 2)
4. Remove the control panel. (Refer to Section 3)
5. Remove the air guide upper. (Refer to Section 4)
6. Remove the compressor, turbo fan, axial fan.
(Refer to Section 5)
7. Remove the motor. (Refer to Section 6)
8. Remove 2 screws that secure the shroud to the base
pan. (See Figure 23)
9. Lift air guide lower and shroud upward.
(See Figure 23)
10. Re-install by referring to the procedures above.

Electrical Parts

8. OVERLOAD PROTECTOR
1. Remove the front grille and cabinet.
(Refer to Section 1, 2)
2. Remove the nut which fastens the terminal cover.
3. Remove the terminal cover.
4. Remove all the leads from the overload protector.
5. Remove the overload protector.
6. Re-install the components by referring to the
removal procedure above. (See Figure 24)
9. COMPRESSOR
1. Remove the front grille and cabinet.
(Refer to Section 1, 2)
2. Discharge the refrigerant by using a refrigerant
recovery system.
3. Remove the overload protector.
(Refer to Section 8)
4. After discharging the unit completely, unbrace the
suction and discharge pipes at the compressor con-
nections.
5. Remove 3 nuts which fasten the compressor.
6. Remove the compressor.
7. Re-install by referring to the removal procedure
above. (See Figure 25)
Figure 22
Figure 23
Figure 24
Figure 25
Service Manual 15
Disassembly