Asko DBI654IB Operating Instructions Manual page 19

Table of Contents

Advertisement

Problem
Water remains in the dishwasher.
Bad odour in dishwasher.
The dishes are not dry enough.
Possible causes
The filters are blocked.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in corners.
Low temperature programs have been selected
for a prolonged period.
Depending on the load, the programme's drying
cycle may be insufficient.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage is set too
low.
Action
Clean the coarse and fine filters.
Check that the filter handle is locked in the stop
position. The handle should point towards the
back of the dishwasher.
Clean the drainage pump. See the chapter Care
and cleaning.
Check that the coloured stop on the right in the
bottom drain is in place. See the chapter Care
and cleaning.
Check that the hose is free from kinks and sharp
bends.
Disconnect the drainage hose where it connects
to the sink unit's water trap. Check that no debris
has fastened and that the connection has an in-
ner diameter of at least 14 mm.
Clean with washing-up brush and low foaming
cleaner.
Run a program with a higher temperature once
or twice a month. Or run a self-cleaning program.
See Self-cleaning in Chapter Using the dishwash-
er.
Activate the Extra Dry option.
Fully load the dishwasher.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings.
Open the door a little once the program has fin-
ished.
19

Advertisement

Table of Contents
loading

Table of Contents