Samsung DA-F760 User Manual page 16

Wireless audio with dock
Table of Contents

Advertisement

Available languages

Available languages

To connect the Wireless Audio with Dock to a Wireless Network
This section describes 3 methods of connecting the Wireless Audio with Dock to a wireless network.
`
Some of network related operations may be different than explained depending on performance and
supported functions of used AP.
`
To configure the network connection to your router or modem, see the router or modem's user manual.
`
The Wireless Audio with Dock supports the following security protocols:
- WEP ; Open
- WPA-PSK ; TKIP
- WPA2-PSK ; AES
`
You can also connect the Wireless Audio with Dock to a network that does not have security and has no
password.
`
If your wireless router supports DHCP, this Wireless Audio with Dock can use a DHCP or static IP address
to connect to the wireless network.
`
Select a channel on the wireless router that is not currently being used, if the channel set for the wireless
router is currently being used by another device nearby, it will result in interference and communication
failure.
`
If you select the Pure High-throughput (Greenfield) 802.11n mode and set the encryption type on your
router to WEP or TKIP, then the Wireless Audio with Dock will not support a connection in compliance with
new Wi-Fi certification specifications.
`
Wireless LAN, by its nature, may cause interference, depending on the operating conditions (router
performance, distance, obstacles, interference with other radio devices, etc)
`
WPS(PBC) / WPS(PIN) does not operate when the security protocol is set to WEP.
`
If you fail to set up the network, press and hold the WPS/RESET button on the rear panel until the
indicator blinks twice. Wait until the red light stops blinking, turn off and on the unit. And try again.
To connect the Wireless Audio with Dock using WPS (PBC)
1. Press the
Dock repeatedly until the
• Each time you press the button, the selection changes as
follows :
The indicator changes from white to red and blinks.
2. Press and hold the WPS/RESET button on the rear panel with a
pen tip or similar item for more than 1 second. The indicator blinks
once in white. After the indicator blinks, release the button.
• The indicator blinks in red.
3. Push the WPS/RESET button on your router or modem within 90
seconds.
4. After the Wireless Audio with Dock connects, the
• The network connection is complete.
16
English
button on the top panel of the Wireless Audio with
icon appears in the display.
;
;
;
;
;
indicator changes from blinking red to white.
PUSH
LAN
WPS / RESET
AUX IN
ONLY FOR
SERVICE
USB 5V 500mA
POWER
LAN
WPS / RESET
AUX IN
ONLY FOR
SERVICE
USB 5V 500mA
POWER

Advertisement

Table of Contents
loading

Table of Contents