Hardware Installation Procedure; Administrator Installation And Setup - Edimax PS-1206P Quick Installation Manual

1.3 Hardware Installation Procedure

Unpack the print server package and verify that all the items

listed in the previous section are provided.
Connect the print server to the printer you want to share on

the network by standard USB or Parallel cable.
Connect the print server to your network by attached the

network cable to the UTP port of the print server.
Connect the power adapter to the print server. The print

server will perform the Power-On-Self-Test (POST) after it is
powered on. During the POST, the status LED will flash.
When the status LED is unlighted, the print server is ready.
Note: You must use the power adapter shipped along with the
print server, do NOT use any other power adapter from other
sources.

1.4 Administrator Installation and Setup

The Administrator Installation Program executes a wizard-driven
procedure that performs the following tasks:
Install all necessary utilities and drivers in your PC (including

the client utilities).
Prompt to setup the print server (including the print server

name and network protocols).
Add the network port of the print server to your PC.

After the installation, perform the standard "Add Printer"
procedure and choose the print server's "Network Port" in the
"Available Ports" list. Then, you can test printing function from the
Administrator PC.
The Administrator Installation can be performed on Windows
95/98/Me/NT/2000/XP with the same user interface. Before the
installation, please verify that your network protocol is installed on
your PC (TCP/IP, IPX and/or NetBEUI). Please follow the steps
below to start installation.
3