It is particularly important to use an RCD together with portable products that are plugged into an electrical supply not protected by an RCCB. If in doubt consult a professional electrician. You may obtain a Residual Current Device by contacting your Sealey dealer. you must also read and understand the following instructions concerning electrical safety.
Ideal for industrial use where 400V 3ph supply is not a problem. These two top of the range 3ph units, are covered by the Sealey 12 month warranty plus an additional 24 months on the main transformer. POWERMIG3525 and POWERMIG3530 both feature a spot welding timer.
CONTROLS - POWERMIG 3525 & 3530 tip to direct gas flow towards the weld ensuring the arc welding 7.1.1 Fig.17 illustrates the main panel controls for Powermig3525. Note that process is shielded from oxidising air contamination (fig.19). The this model has a single voltage adjustment switch and one socket on shielding gas also assists heating of the weld.
Page 7
- Replace the wire puller rollers with aluminium compatible rollers. - Replace the steel guide hose for wire feed with a Teflon guide hose. - For more information contact your local Sealey dealer . Preparation for welding. SPOT WELDING (fig.20) IMPORTANT: BEFORE YOU COMMENCE, MAKE SURE THE 9.3.1...
WARNING! Ensure the unit is disconnected from the mains card, or expensive machine repairs. To keep the contact tip free from spatter, we recommend the use of Sealey anti-spatter spray power supply before performing any maintenance or service. (MIG/722307) available from your Sealey Dealer.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500. NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.