Maintenance; Replacement Parts - Dyna-Glo Workhorse EG7500WH Installation & Maintenance Instructions Manual

1. Before cleaning, make sure the power has been turned off at the circuit breaker
panel and that the heating element of the heater is cool.
2. To maintain the external appearance of the heater, the unit occasionally needs to
be wiped with a dry duster. During the summer months, or at other times when
the appliance is not in use and is completely cold, it should be the wiped over
with a damp cloth.
3. Do not use abrasive cleaning powders or furniture polish. Do not use chemical or
abrasive products, metallic scourers and so on, which may deteriorate the sur-
face, to clean the appliance.
4. During the summer months, or at other times when the appliance is not in use,
disconnect the power supply. Keep the appliance in a dry and cool place.
5. All other servicing should be performed by qualified service personnel. Do not try
to repair the heater yourself.
NOTE: The motor is permanently lubricated, and no further lubrication is needed.
Part Description
1 Back mesh
2 Hanging plate
3 Fan Blade
4 Air guide plate
5 Large handle seat
6 Small handle seat
7 Spring
8 Motor

MAINTENANCE

REPLACEMENT PARTS

Part# Part
EG5000001AC
EG5000002AC 10
EG5000003AC 11
EG5000004AC 12
EG5000005AC 13
EG5000006AC 14
EG5000007AC 15
EG5000008AC 16
12
Description
9 Heater
Selection Switch
Main Board
Terminal block
Temperature CUT-OFF
Control Panel Circuit Board EG7500WH002AC
Control Panel box
Infrared Remote Control
Part#
EG7500001AC
EG5000011AC
EG7500WH001AC
EG5000014AC
EG5000017AC
EG7500WH003AC
EG7500WH004AC