Table of Contents
Advertisement
2.2.3. PROGRAM SATELLITES
This sub-menu allows you to customize the system setup to add an additional satellite into
your receiver. Note that the menu page is dynamic which means that it changes with the
selections you make. You can customize and view:
2.2.4. USER LNB SETTING
This sub-menu allows you to program a LNB that is not listed in the LNB selection list. Note
that the menu page is dynamic which means that it changes with the selections you make.
You can customize:
Digital Satellite Receiver
Familiarization
Satellite
To set the satellite you want to scan for the LNB.
Search mode
To set a specific search mode (All, FTA, IF, TP,
network or update).
Longitude
To view the satellite location on the Clarke Belt.
Transponder
To select a transponder of the selected satellite.
Skew
To adjust the Horizontal/Vertical setting (only for
polarotor).
Location
To move the dish for best signal level and quality.
Satellite offset
To compensate for a dish offset caused by ambient
conditions.
NOTE
The satellite offset will affect all satellite positions,
this means that all scanned positions will change
which might result in total loss of signal for all
satellites.
Search Channels
To confirm the selections you made and advance
to the Search Channels page.
User's LNB
To select the first or second user defined LNB.
Low Frequency
To enter the low frequency of the user LNB.
High Frequency
To enter the high frequency of the user LNB.
Polarity Control
To select the device that controls the polarity.
Band Control
To set the control signal for high or low band
selection.
Ku/C Control
To set the control signal for the Ku/C LNB.
Save settings
To confirm the selection and save the settings.
Section 4
4
Page 4 - 9
Advertisement
Table of Contents
