Table of Contents
Advertisement
Available languages
Available languages
English
Fig. C
18
3. Press the front shroud button
shroud button
8
at the same time to fully open the
cutting shroud.
4. Loosen the collar screw
2
align the tabs
20
on the cutting shroud with the
slots
on the grinder gear case.
21
Fig. D
21
5. Rotate the shroud into the desired working position. The
shroud should be positioned between the spindle and
the operator to provide optimum efficiency.
6. Tighten the collar screw
on the gear case. Do not operate the grinder with a
loose cutting shroud.
7. To remove the cutting shroud, loosen the collar screw,
rotate the cutting shroud to align the slots and tabs and
pull up on the cutting shroud.
nOTE: The cutting shroud is pre-adjusted to the diameter of
the gear case hub at the factory. If, after a period of time, the
cutting shroud becomes loose, tighten the collar screw
Only adjust the collar screw when it is on the grinder
otherwise the collar can be damaged.
NOTICE: If cutting shroud cannot be secured by
tightening the collar screw, do not use tool. Take the
tool and cutting shroud to a service center to repair or
replace the cutting shroud.
Mounting and Using Type 1 (Cutting)
Diamond Wheels (Fig. A, E, F)
WARNING: Only Type 1 Diamond Wheels shall be
used with cutting shroud. Do not cut metal. Do not
use with bonded abrasive wheels.
CAUTION: Do not use the shroud with the grinder
flanges. Only use the shroud with the flanges provided
with it.
1. With the cutting shroud attached to the grinder,
press the front shroud button
6
19
and the side
7
on the cutting shroud and
2
20
to secure the cutting shroud
2
2
and the side
7
shroud button
8
at the same time to fully open the
cutting shroud.
Fig. E
7
2. Remove the backing flange that is on the grinder (and
keep it for conversion back to a grinder).
3. Install the backing flange,
iMPORTAnT: The DWE46125 comes with two sets of
flanges. Refer to the Flange/Grinder Compatibility
Chart at the end of this section for proper use.
4. Place the wheel
24
and place both on the spindle, against the backing
flange, centering the wheel on the raised center of the
backing flange.
5. While depressing the spindle lock button, tighten the
locking flange using a wrench.
6. To remove the wheel, depress the spindle lock button
and loosen the locking flange.
Fig. F
.
Flange / grinder Compatibility Chart
Flange set
Short (silver)
flange set:
Locking flange
11
Backing flange
12
8
or
, on spindle
12
14
on the locking flange
11
or
11
24
12
25
grinder
DCG413
.
25
13
,
Advertisement
Table of Contents
