Advertisement
ENGLISH
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage.
Always check that the mains voltage
corresponds to the voltage on the rating
plate and the information in the technical
data table.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
Never attempt to charge
u
nonrechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
8
(Original instructions)
Symbols on the charger
Read all of this manual carefully
before using the appliance.
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this ap-
pliance along with the date code.
Read all of this manual care-
fully before using the appli-
ance
Only use with charger
JOD-S-150050**
JOD-S-150050**
Features
This tool includes some or all of the following features.
1. Dust bowl cover release button
2. Dust bowl
3. Prefilter
4. Filter
5. Battery pack
6. Battery pack release button
7. Crevice nozzle
8. Brush
9. Charging stand
10. Charging adapter
11. Power button
12. Unit body
13. Wide mouth dust brush (only for DVC320B01)
Operation
Press the Power Button (11) as shown in figure A
u
Unit starts in high speed. press button again to slow
u
speed.
Press the Power Button once more, the appliance stops
u
working.
Advertisement
