Assembly Preparation; Folding And Unfolding - Hiboy S2R User Manual

3. Assembly
Preparation Preparation
1
2
1
1. Unfold the stem and close the folding mechanism until
you hear a click. Then turn the locking lever and insert into
Attach the steering column Connect the cable from the
Attach the steering column Connect the cable from the
the hole and you hear the other click.
and fold out the kickstand. handlebar to the cable from
and fold out the kickstand. handlebar to the cable from
the steering column.
the steering column.
3 4
3
3
3. Ensure your scooter can be turned on and off.
Place the handlebar on the
steering column. the handlebar with the 6
Place the handlebar on the
screws.
Preparation
1
2
2. Note: Please connect the wire on the inside of the
handlebar to the wire that is on the inside of the stem.
Attach the steering column
Then slide the handlebar onto the stem, make sure it'
and fold out the kickstand.
the right way round.
3
4 3
4. Put the all 6pcs screws into the holes,then tighten
4 the each screws properly.
Place the handlebar on the
ATTENTION:
2
Connect the cable from the
handlebar to the cable from
the steering column.
Double Lock Folding Mechanism
You have to finish below 2 steps before riding,
1. Unfold the stem and close the folding mechanism until you hear a click.
4 2. Then turn the locking lever and insert into hole and you hear the other click.
storage. Proceed as follows:
9. Folding&Unfolding
1
2
When folding the scooter,switch off the electric scooter,loosen the lock lev
on the rear fender; When unfolding the scooter, unlock the bell clip from th
position, and fix the folding mechanism.
5
1. Open the lo
ing column.