Canon PS-7000 Service Manual page 10

4.2. HDD
1) Replacement or format
Before replacing or formatting the HDD, please be sure to notify customers that data downloaded
by customers, such as fonts, can be lost.
2) Service part HDD
Service part HDD have already been formatted, and there is no need to format it again before use.
(For HDD formatting, please see page 4-13.)
Notes: The HDD format used in this manual is for recognition by PostScript system,
and it is completely different from that performed under Windows (DOS) or
Macintosh.
3) Master / Slave setting
If an additional HDD is installed, the jumper must be set as shown below to identify the slave
HDD from the master HDD.
Slave HDD
Master HDD
4.3. Network Board
After replacement of the Network Board, network-related parameters such as IP address must be set
again. For setting the IP address, use the TCP/IP setting utility (Pnconfig) in the CD-ROM (Canon
Hardware RIP PS-7000 CD) packed with the product.
4.4. Prevention against electrostatic destruction
When disassembling the PS-7000, please place it on the conductive mat (or sheet) and put on the wrist
belts for a ground. The PCB, memory modules, and HDD used for the PS-7000 are weak to static
electricity.
1-7
Chapter 1 Safety Instructions
Jumper