Internet Or Ethernet Port Leds Are Off; Wifi Led Is Off; You Cannot Log In To The Router - NETGEAR R7960P User Manual

Ac3600 tri-bandwifi router
Hide thumbs Also See for R7960P:
Table of Contents

Advertisement

Nighthawk X6S AC3600 Tri-Band WiFi Router Model R7960P
If the error persists, a hardware problem might be the cause. Contact Technical Support
at netgear.com/support.

Internet or Ethernet Port LEDs Are Off

If either the Ethernet port LEDs or the Internet LED does not light when the Ethernet
connection is made, check the following:
• Make sure that the Ethernet cable connections are secure at the router and at the
modem or computer.
• Make sure that power is turned on to the connected modem or computer.
• Be sure that you are using the correct cable.
When you connect the router's Internet port to a modem, use the cable that was supplied
with the modem. This cable can be a standard straight-through Ethernet cable or an
Ethernet crossover cable.

WiFi LED Is Off

If the WiFi LED stays off, check to see if someone pressed the WiFi On/Off button on
the router. This button turns the WiFi radios in the router on and off. The WiFi LED is lit
when the WiFi radios are turned on.

You Cannot Log In to the Router

If you are unable to log in to the router from a computer on your local network, check
the following:
• If you are using an Ethernet-connected computer, check the Ethernet connection
between the computer and the router.
• Make sure that the IP address of your computer is on the same subnet as the router.
If you are using the recommended addressing scheme, your computer's address is
in the range of 192.168.1.2 to 192.168.1.254.
• If your computer's IP address is shown as 169.254.x.x, recent versions of Windows
and Mac OS generate and assign an IP address if the computer cannot reach a DHCP
server. These autogenerated addresses are in the range of 169.254.x.x. If your IP
address is in this range, check the connection from the computer to the router, and
reboot your computer.
• If your router's IP address was changed and you do not know the current IP address,
clear the router's configuration to factory defaults. This sets the router's IP address
to 192.168.1.1.
Troubleshooting
161
User Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nighthawk x6s

Table of Contents