Table of Contents
Advertisement
➙ Network Settings ➙ Network Interface Port and select Shared. Then, go to Shared NIC on and select
PHY Card.
Rear view of server models with two PCIe slots
The following illustration shows the rear view of the server models with two PCIe slots. Depending on the
model, your server might look slightly different from the illustration below.
Figure 8. Rear view of server models with two PCIe slots
Table 5. Components on the rear of the server
1
PCIe slot 1 on riser 1 assembly
3
Power supply 1
5
NMI button
7
VGA connector
9
Ethernet connectors on LOM adapter (available on
some models)
1 2
PCIe slots on riser 1 assembly
Your server supports three types of riser cards for riser 1 assembly.
• Type 1
– Slot 1: PCIe x16 (x8, x4, x1), low-profile
– Slot 2: PCIe x16 (x16, x8, x4, x1), full-height, half-length
• Type 2
– Slot 1: ML2 x8 (x8, x4, x1), low-profile
– Slot 2: PCIe x16 (x16, x8, x4, x1), full-height, half-length
• Type 3
– Slot 1: ML2 x16 (x16, x8, x4, x1), low-profile
– Slot 2: PCIe x16 (x8, x4, x1), full-height, half-length
3
Power supply 1
4
Power supply 2 (available on some models)
The hot-swap redundant power supplies help you avoid significant interruption to the operation of the
system when a power supply fails. You can purchase a power supply option from Lenovo and install the
power supply to provide power redundancy without turning off the server.
On each power supply, there are three status LEDs near the power cord connector. For information about the
LEDs, see "Rear view LEDs" on page 19.
5
NMI button
18
User Guide for ThinkAgile HX2320 Appliance and HX2321 Node
2
PCIe slot 2 on riser 1 assembly
4
Power supply 2 (available on some models)
6
USB 3.0 connectors
8
XClarity Controller network connector
Advertisement
Table of Contents
