Maintenance - Shark NV44 Owner's Manual

Maintenance

Resetting the Motor Thermostat
Your Shark Navigator
®
Upright Vacuum is equipped with
a protective Motor Thermostat. If
the motor should overheat, the
thermostat shuts off the power.
To reset the Motor Thermostat:
Move the Power Button to the
"O – Off" position.
Unplug the vacuum.
Check for clogged hose or filter;
unclog hose and replace filter.
Refer to Checking for Blockages
on page 11.
12 TOLL FREE: 1-800-798-7398
NV44_26_IB_E_130124_1.indd 12
Plus
®
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Turn the Power Switch to the
"I – On" position to start the
vacuum.
Note: if vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
A
1 Cleaning the Power Brush -
Turn the Power Brush over and
slide locking latch (A) forward.
Gently tilt brush housing upward
to open.
Remove debris from turbine
wheel and air passage.
To reassemble, insert the tabs on
the front edge of the cover into
the matching holes in the top
half and tilt the cover back down
until it clicks into place.
Ordering Replacement Parts
To order additional parts and
accessories, go to
www.sharkclean.com
or call 1-800-798-7398.
PART PART NO.
Dusting Brush &
Crevice Tool
Foam & Felt Filters
Power Brush
Cleaning Wand
24"Crevice Tool
13-01-24 11:36 AM
1115FC
XFF36
143FFJ
1116FC
1124FC