Transfer Chassis To A Mechanical Lifting Device - Cisco 8800 Series Hardware Installation Manual

Transfer Chassis to a Mechanical Lifting Device

Step 3
Repeat Steps 1 and 2 to attach the other bottom-support rail to the rack.
Note
What to do next
Mount the chassis into the rack.
Transfer Chassis to a Mechanical Lifting Device
Procedure
Step 1
Place the mechanical lifting device in front of the chassis on the pallet (or on Line Card side) as shown.
Figure 10: Align the Lifting Device in Front of the Chassis on the Pallet
Step 2
Prepare to use the mechanical lifting device by placing a piece of cardboard on the surface of the lift (to
prevent scratching).
Step 3
With at least two or three people move the chassis carefully from the pallet onto the lifting device as shown.
Hardware Installation Guide for Cisco 8800 Series Routers
24
Make sure that the two bottom-support rails are level with one another. If they are not level, adjust
the higher rail down to the level of the lower rail.
Unpack and Install the Chassis