Advertisement
Available languages
Available languages
ANOMALY
ALARM
Emergency key
The keypad is provided with an emergency call key.
If it is pressed for 2 seconds at least, an internal relay will change over for 3 minutes.
This contact can be managed both by the burglar alarm control unit and by a telephone
dialler to transfer the alarm.
TERMINALBOARD DESCRIPTION
Terminal n.
1
2
3
4
5
6
7
8
9
APPLICATION FOR ELECTROLOCK CONTROL OR CONNEC-
TION OF BURGLAR ALARM CONTROL UNIT WITH STANDARD
INPUT (diagram 2)
Thanks to this application, the keypad can be used to enable/disable burglar alarm
systems not manufactured by AVE or to control an electrolock by transforming the key-
pad serial output into a potential-free contact of the programmable decoder code
45378DF.
Storing the master code
There are no differences compared to the previously described phase 1.
Keypad code programming and decoder storing
1) Insert programming jumper J2 into the decoder code 45378DF (fig.3C).
2) Proceed as per items 2), 3) and 4) of the previously described phase 2.
ZONE A green led: flashing.
It summarizes one or several following situations:
• flat battery (the control unit cannot be connected; disconnection is
possible)
• one or several lines are open (this signal is displayed only if the
control unit is disconnected)
• one or several lines are excluded by means of special zone exclu-
sion pushbuttons seated on the control unit (this signal is displa-
yed only if the control unit is disconnected)
ZONE C red led: flashing. It indicates that one or several system
zones enabled have been tampered and/or forced (this signal is dis-
played only if the control unit is connected)
Description
Power supply negative
Power supply positive
Serial line signal for AVE burglar alarm control units
Serial line signal for 45378DF decoder
Emergency alarm NO contact
Emergency alarm C contact
Emergency alarm NC contact
Tamper
Tamper
!
- 14 -
Advertisement
