BIOS Beep Codes
BIOS Beep Codes Table
PEI Beep Codes
# of Beeps
1
1
2
3
3
4
4
7
DXE Beep Codes
# of Beeps
1
4
5
5
6
7
8
BIOS Recovery Instruction
AMI has an embedded recovery technique. In the event that the BIOS becomes corrupt the boot block can be used to
restore the BIOS to a working state. To restore your BIOS, please follow the instructions listed below:
Recovery Instruction:
1
Prepare a bootable handy drive or floppy diskette
2
Copy the image file to the bootable hand drive or the bootable floppy diskette.
3
Rename the image file to "FLASHABL.ROM".
Description
Memory not Installed.
Memory was installed twice (InstallPeiMemory routine in PEI Core called twice)
Recovery started
DXEIPL was not found
DXE Core Firmware Volume was not found
Recovery failed
S3 Resume failed
Reset PPI is not available
Description
Invalid password
Some of the Architectural Protocols are not available
No Console Output Devices are found
No Console Input Devices are found
Flash update is failed
Reset protocol is not available
Platform PCI resource requirements cannot be met
61