Table of Contents
Advertisement
24
6
Lift the fan module out of the chassis.
Install the Server Board
Caution:
Do not install any server board support bumpers in the Altos R700
chassis.
System components must be installed in the order presented
below. If installed in a different order, component damage may
occur.
1
Ensure that the insulator sheet is seated securely over the
standoffs, is laying flat on the chassis floor, and that the edge of
the sheet is seated below the studs in the rear chassis wall.
2
Remove the server board from its packaging and antistatic bag.
3
While placing the board on the chassis standoffs, carefully position
the board I/O connectors in the rear chassis I/O openings.
4
Adjust board position so that the mounting holes rest securely on
the corresponding shouldered standoffs.
2 Assembling the System
Advertisement
Table of Contents
