Provisioning The Litespan H2Tu-C Via Tl1 Commands - ADTRAN H2TU-C Installation And Maintenance Practice

Asynchrononous line cards for litespan channel bank assemblies using narrowband and wideband pairs

Hide thumbs Also See for H2TU-C:

Table of Contents

Appendix B, Litespan H2TU-C Provisioning Tutorial - Provisioning the Litespan H2TU-C via TL1 Commands

PROVISIONING THE LITESPAN H2TU-C VIA TL1 COMMANDS

The Litespan H2TU-C is an asynchronous DS1 line card that plugs into the Channel Bank

Assembly (CBA) of an Alcatel Litespan-2000 or Litespan-2012 optical loop carrier system.

There must be one ADS1U module in the Central Office Terminal (COT) Litespan CBA for each

Litespan H2TU-C installed in the Remote Terminal (RT). Install one ADS1U in the COT (or

ensure that one is already installed) for each Litespan H2TU-C to be provisioned.

Perform the following steps to install the Litespan H2TU-C into a Litespan CBA and establish

basic provisioning for the T1 facility.

TL1 commands are shown here in

sequences must be exact. A semicolon ends the string at any point

if the remaining parameters are to be left unchanged or in their

default states.

1. Determine if a cross-connect exists for the slot in which the H2TU-C is assigned by enter-

ing the following command:

RTRV-CRS-T1::<TERMINAL>-<BANK>-<SLOT>;

(See

Table B-1

for details on the RTRV-CRS-T1 command.)

2. Does a cross-connect exist on the slot?

If yes, go to Step 3.

If no, go to Step 4.

61221002L1-5F

NOTE

. Colon and comma

BOLD

B-5

Table of Contents