Thermal Module Installation - Acer AOHAPPY2 Service Manual

3. Remove the thermal module from the mainboard as shown in Figure 3-22.
Figure 3-22. Thermal Module Removal

Thermal Module Installation

+
IMPORTANT:
Apply approved thermal grease and ensure all heat pads are in position
before replacing
CAUTION:
!
Use caution when applying thermal grease. Thermal grease may cause
damage to the mainboard.
The following thermal grease types are approved for use:
Silmore GP50
Honeywell
Jet Motor 7762
The following thermal pads are approved for use:
Eapus XR-PE
1. Remove all traces of thermal grease from CPU using a lint-free cloth or cotton swab
and Isopropyl Alcohol, Acetone, or other approved cleaning agent.
2. Apply small amount of thermal grease to center of CPU.
NOTE: NOTE:
Force used during installation of thermal module is sufficient to spread grease
evenly over CPU top.
3. Install and secure two (2) non-captive screws (C) in numerical order from one (1) to
four (2) to mainboard. Refer to
4. Connect thermal module cable (A) to mainboard connector (B). Refer to
5. Install mainboard.
3-26
module.
Figure 3-21.
Machine Maintenance Procedures
0
Figure 3-21.